-
- Bearings
Thrust Bearings
Our Thrust Bearings including two washers and a cage, the washers use high hardness chrome steel which can bear a large load. These are great bearings and can be used in our Actuator Kits and C-Beam Kits.
-
- Bearings
688ZZ Ball Bearing
This Flanged Bearing is a chrome steel instrument bearing suitable for many applications.
They can be used with our 8mm ACME Lead Screws and our Threaded Rod Plate.
-
- Bearings
Linear Bearing RJMP
These Linear Bearing is used to slide along a 6mm / 8mm / 10mm / 12mm smooth rod.
These are very slim, and good for when you want to attach a motion carriage onto a railing without adding a lot of weight.
-
- Bearings
Female Fish Eye Rod End Bearing Joint
These Fish Eye Rod End Bearings usually attach to the end of a hollow threaded rod or a tube.
-
- Bearings , - MGN
Linear Slide Bearing Block MGN 7C/7H/9C/9H/12C/12H/15C/15H
This special edition High Quailty Black Linear Bearing is a small light weight rail slide block suitable for miniature equipment.
-
- Bearings
Pillow Block Mounted Bearing
KP Series Bearings are widely used in industrial machines and other DIY projects.
These bearings have screws on the bearing’s inner collar to hold the shaft.
-
- Bearings
Pillow Block Flange Bearing
This Bearing is a self-aligning, pillow block bearing, you can adjust or replace the bearing easily.The bearing has a wide inner ring with two set screws for attaching to the shaft.
-
- Bearings
Ball Bearing 625 2RS & 625 ZZ
These little 625 2RS ball bearings are the same bearings that are included with the Dual V Wheel Kits.
-
- Bearings
Male Fish Eye Rod End Bearing
These Fish Eye Rod End Bearings usually attach to the end of a hollow threaded rod or a tube.
-
- Bearings
Linear Bearing Slide Block
This Linear Bearing Block (Pillow Block) is used to slide along an 10mm smooth rod.
These have a 30*25mm / 35*30mm / 40*35mm / 42*36mm / 44*38.5mm platform and four holes tapped for M4 machine screws – so you can attach pretty much anything you want.
-
- Bearings
Linear Motion Ball Bearing
These liner-motion bearings are made of high quality bearing steel for low noise and long service life.
They are double sealed to avoid contaminants entering and save lubricant.
-
- Bearings
MR105ZZ Sealed Shielded Ball Bearing
Miniature and instrument ball bearings can be divided into two basic types, deep groove and angular contact.
The first (deep groove) can also be classified as “Open”, “Shielded”, or “Sealed” depending on the existence and type of seal or shield.
Bearing
Showing 1–12 of 14 results