This Shield is designed to work with our C-Beam Extrusion to protect debris from falling into the transmission. With it’s clean silver finish this Shield is a perfect addition to any C-Beam project.

Our shield comes in two lengths. 273mm length is designed for our 250mm C-Beam Actuator. 523mm length is designed for our 500mm C-Beam Actuator.

In order to incorporate the C-Beam Shield onto to your C-Beam Actuators, you will need our C-Beam Riser Plates & M5 x 10 mm Low Profile Screws.

Grab yours here: C-Beam Shield

Categories: Item introduction

0 Comments

Leave a Reply

Your email address will not be published. Required fields are marked *